- setEndCapStyle
Specifies the end cap style of the generated buffer. The styles supported are
#CAP_ROUND, #CAP_FLAT,
- setJoinStyle
Sets the join style for outside (reflex) corners between line segments.
Allowable values are #JOIN_R
- setQuadrantSegments
Sets the number of line segments used to approximate an angle fillet. * If quadSegs >= 1, joins are
- <init>
Creates a set of parameters with the given parameter values.
- setMitreLimit
Sets the limit on the mitre ratio used for very sharp corners. The mitre ratio
is the ratio of the d
- setSingleSided
Sets whether the computed buffer should be single-sided. A single-sided buffer
is constructed on onl
- getJoinStyle
Gets the join style
- getMitreLimit
Gets the mitre ratio limit.
- getQuadrantSegments
Gets the number of quadrant segments which will be used
- isSingleSided
Tests whether the buffer is to be generated on a single side only.
- getSimplifyFactor
Gets the simplify factor.